If you already have a LinkTap system in the house, please start from Step 3 below. Connect LinkTap Gateway to a LAN port of your home broadband modem (or a network switch, a router, a hub, a Wi-Fi extender) using the supplied ethernet cable. A rule of thumb is that the two input wires of the DC latching solenoid are of different colors (for example, one red and one black). The ValveLinker can only control the 9-24V DC latching solenoids; it can NOT drive any type of AC solenoids, nor can it drive semi-direct lift solenoid valves. You can use email address of your neighbors, friends, family members, or colleagues, so that when a fault occurs but you are unable to handle the failure in time for some reason, they can help you out. The LinkTap ValveLinker is a wireless valve controller for operating 9-24V DC latching solenoid valves. Insert two 9V alkaline (or lithium, rechargeable lithium) batteries into the ValveLinker in the correct orientation, then switch on the device. When a fault occurs, in order to avoid false positives, the system will make multiple measurements, so sending out real-time push notifications and emails will be delayed by 10 to 45 seconds. In addition, you can test the Instant watering function through the app. For more information, please consult your local professional plumber. Please pay attention to the polarity of the wires when connecting the solenoid. Operating water pressure range: 0.02-0.8MPa or 2.9-116 psi, Watering duration per cycle: 3 seconds to 23 hours 59 minutes Temperature of water flow: 1C to 40C, Flowmeter measurement range: 3 to 120 L/min with a measurement error of 5%, Wireless water timer power: two 9 volts alkaline, lithium, or rechargeable lithium batteries, Wireless transmission distance: up to 800m *, Max. In addition, if the device is placed below the ground, the LinkTap Gateway should be placed as high as possible (for example, upstairs). The device must have been handled properly and in keeping with the requirements of the operating instructions. Register the Gateway through LinkTap free mobile app or web app. The connectors of the flow meter cables are waterproof. If the actual flow rate is less than 2 liters/min, the flow meter may not detect the water flow, so the flow rate value on the app will be displayed as 0.If the preliminary watering test is ok, you can press the blue button on the ValveLinker again to close the solenoid valve. on LINKTAP V1-4Z Wireless Watering System User Manual, Visit https://www.link-tap.com/app-manual, Shenzhen Wonderhuge Electronics WH-919 Active Noise Cancelling Headphones User Manual, Razor MX500 Dirt Rocket Adult & Teen Ride On High-Torque Electric Motocross Motorcycle Dirt Bik Instructions, Razor W13111701003 Electric Party Pop Electric Tekno Installation Guide, MALYAN MA20 FDM Belt 3D Printer User Manual, Suntech ST4345GPS Enabled LTE CAT-M1 AVL Device User Manual, KVIDIO WH201A Wireless Headphones User Manual, Gerni GPW-3600 240V High Pressure Washer Instruction Manual, enbrighten LED Wi-Fi Smart Caf Lights Instruction Manual, iRobot i3 / i4 Roomba Robot Vacuum Owners Manual, SHARP Digital Alarm Clock SPC276 User Manual. Something went wrong. To reduce possible interference, please place the Gateway over 30cm (or 1 foot) away from any power sockets and/or other electronic devices. If your ValveLinker is a 2-zone or 4-zone model, there will be 2 or 4 ValveLinkers displayed on the app, and each of the ValveLinker can be controlled independently. ), there is still an extremely low chance of false positives or false negatives. If the flow meter has been installed, the ValveLinker can detect the following faults in a real-time manner and then send push notifications and emails to you and your nominated person, e.g. Actual ranges may vary depending on environmental conditions, building materials, etc. Before fixing the ValveLinker to a certain location, you can check the wireless receiving signal strength and connection performance of the device through the tool. When the registration is completed, the Synced LED on the Gateway will turn solid green. The two cables have different configurations and therefore cannot be used. When installing the flowmeter on the pipe, be careful not to let soil, dust, water, or other substances enter the waterproof connector of the flow meter. Tip: The location of the ValveLinker and the Gateway has a great impact on the wireless performance of the devices. For more information on this issue, please refer to the FAQ (www.link-tap.com/faq). The distance between the ValveLinker and the solenoid valve & the flow meter should not exceed the length of the connection cables. If the flow meter has been installed, you can verify the water cut-off detection and notification process by following the steps below. The ValveLinker comes with 3 models: 1-zone (V1-1Z), 2-zone (V1-2Z) and 4-zone (V1-4Z). Press the blue Manual On/Off button once to start or stop watering. Turn on the main valve on the pipe first, then press the blue Manual On/Off button on the ValveLinker to open the solenoid valve. This device meets the FCC and IC requirements for RF exposure in public or controlled environments. The ValveLinker comes with two connection cables: one is used to connect the ValveLinker and the solenoid valve, and the other is used to connect the ValveLinker and the flow meter. Damage caused by frost is not covered by the warranty. Install the DC latching solenoid valve and optional flow meter on the PVC pipes, then connect the ValveLinker with the solenoid and flow meter using the supplied connection cables and waterproof connectors. Under warranty we will either replace the device or repair it free of charge if the following conditions apply: LinkTap has done its utmost to ensure that the fault detection & notification function works reliably. For the 2-zone and 4-zone models, please pay attention to the serial number of the wire when connecting the flow meters. neighbor, friends, etc. The device damage due to incorrect or improper installation will not be covered by the warranty. If you are in an area where the pipeline is at risk of freezing in the winter, you need to take proper measures to prevent the solenoid valve and the pipeline from being damaged in the winter. The LinkTap app comes with aDevice Health Check tool. Trending price is based on prices over last 90 days. However, there is no guarantee that interference will not occur in a particular installation. Copyright 1995-2022 eBay Inc. All Rights Reserved. Log in to the app, go to the Device Details page, then enable Water cut-off alert. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Similarly, when the flow rate changes, the current flow rate value wont be shown on the app until 10 to 30 seconds later. You can also disable, partially enable or fully enable the Manual button lockout function through the app. The ValveLinker will automatically connect to the Gateway in 5~60 seconds, as indicated by 2 solid green LEDs ( and ). The water should pass through the solenoid valve and flow meter, and you can also see the real-time flow rate value on the app. The ValveLinker uses the same LinkTap Gateway as the LinkTap water timers. In addition, be careful not to press the pipe clamp on the connection wire of the flow meter. Add a new ValveLinker device through the LinkTap app. This device complies with Industry Canadas license-exempt RSS. These 2 LEDs will go off after being solid green for 10 seconds to save power. From the perspective of wireless communication, the device should be placed as high as possible, therefore the location above the ground (e.g., on a wall or wooden stake) is desirable. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.FCC Warning: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Home LINKTAP LINKTAP V1-4Z Wireless Watering System User Manual. Use two 9V alkaline, lithium or rechargeable batteries (not included). Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Watering Timers & Controllers, Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like, {"modules":["unloadOptimization","bandwidthDetection"],"unloadOptimization":{"browsers":{"Firefox":true,"Chrome":true}},"bandwidthDetection":{"url":"https://ir.ebaystatic.com/cr/v/c1/thirtysevens.jpg","maxViews":4,"imgSize":37,"expiry":300000,"timeout":250}}. Faults that occur as a result of incorrectly installed or leaking batteries or using third-party power adapter & USB cord are not covered by the warranty. The valve failed to shut down the watering properly; The mains water is turned off, causing no water comes out of the valve; The water flow rate abnormally increases or decreases. You can now remotely access your ValveLinker from anywhere with peace of mind! Operation is subject to the following two conditions: The term IC: before the certification/registration number only signifies that the Industry Canada technical specifications were met. number of Gateways per user account: 6. Be sure to tighten the two connectors to each other. If possible, do not press the pipe clamp against the stainless-steel cover plate on the flow meter. Your email address will not be published. It also works with the LinkTap 1-inch flow meter to measure flow rate and volume. The end user is advised to maintain a distance 20 cm from the timer and any personnel to ensure compliance with RF exposure regulations. A common way is to install a water drain valve or faucet on the pipe before the solenoid valve to drain the water from the pipe. In some scenarios, you may need to move the Gateway closer to the ValveLinker via a Wi-Fi extender. If the connection cables are to be buried in the ground, it is recommended to place the cables inside of a corrugated tube or PVC pipe for more protection. If the device must be placed in the valve box or the device is lower than the ground, it is strongly recommended that an object (such as a wooden stake or brick) is used to lift the ValveLinker so that the device is as close to the ground as possible. Comment document.getElementById("comment").setAttribute("id","a51fd0052465a5d3c1b987a2905f49d0");document.getElementById("afe6277d1c").setAttribute("id","comment"); Save my name, email, and website in this browser for the next time I comment. Visit https://www.link-tap.com/app-manual or scan the QR code for the LinkTap app user manual. LinkTap guarantees the wireless valve controller and gateway products for 2 years from the date of purchase. As shown below, the device can be hanging on a wall, hanging or standing on a hardwood stake, or placed in a valve box. 3 solid green LEDs (Power, Link and Internet) indicate that the Gateway has connected to the LinkTap cloud server. The positive wire (red) of the solenoid needs to be connected with the positive wire (red) of the connection cable, and the negative wire (black) of the solenoid needs to be connected with the negative wire (black) of the connection cable. Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Watering Timers & Controllers. Do not use carbon-zinc batteries, NiMH or Ni-Cd rechargeable batteries. After the ValveLinker has been connected to the solenoid valve and the flow meter, you can perform a preliminary watering test. This process may take up to a few minutes. But if a longer flow meter cable is required in your project, please contact us at [emailprotected], and we will provide you a variety of length cables as optional accessories. LinkTap and its designated agents are not liable for any possible loss caused by false positives or false negatives. This device may not cause interference; and. This device must accept any interference, including interference that may cause undesired operation of the device. item 1 LinkTap G1S Wireless Water Timer & Gateway - Smart Sprinkler Timer with App, 4.9 out of 5 stars based on 13 product ratings, 4.8 out of 5 stars based on 58 product ratings, 4.9 out of 5 stars based on 121 product ratings, 4.7 out of 5 stars based on 168 product ratings, 5.0 out of 5 stars based on 3 product ratings, 4.5 out of 5 stars based on 2 product ratings, 4.9 out of 5 stars based on 58 product ratings. The service life of lithium batteries is about twice that of alkaline batteries. This guarantee covers all serious defects of the device that can be proved to be material or manufacturing faults. This product meets the applicable Industry Canada technical specifications.This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body. The real-time push notifications will be sent to all your smartphones and tablets with the LinkTap app installed, and an email will be sent to your registered email address and two other email addresses. As shown in the figure below, wire #1 needs to be connected to the flow meter working with solenoid valve #1, wire #2 needs to be connected to the flow meter working with solenoid valve #2, and so on. Wireless Headphones User Manual - Optimized PDF Wireless Headphones User Manual - Original PDF, USER MANUAL TRUE WIRELESS STEREO EARPHONES Model: BWD19AAH06, BW019.1-107 PRODUCT GUIDE Product Information 1) Product Name TRUE WIRELESS, Shure UHF Wireless User Manual - Optimized PDF Shure UHF Wireless User Manual - Original PDF. Tip: Placing the Gateway at a higher location will usually increase the wireless coverage. The measurement range of the LinkTap 1-inch flow meter is 3-120 liters/min. View cart for details. Neither the purchaser nor a non-authorized third party has attempted to repair the device. Within 45 seconds, you should receive a water cut-off alert on your phone. However, due to various factors in the real-world (e.g., network delay or interruption, equipment failure, battery quality problems, improper use of the device, etc. Press the Manual On/Off button on the ValveLinker, or activate Instant Watering on the app to start watering. Determine the installation location of the ValveLinker. Please read this user manual thoroughly before installing the LinkTap ValveLinker. Power on the Gateway using the supplied USB cord and power adapter. Enable all fault alert options on the app. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. This device complies with Part 15 of the FCC Rules. Wireless coverage claims are used only as a reference and are not guaranteed as each wireless network is unique. If the signal is weak, or the wireless connection performance is poor, then you need to adjust the location of the ValveLinker or Gateway to achieve a more stable wireless connection. In order to extend the life of the valve and flow meter, it is strongly recommended to install an inline filter before the water enters the valve. If the colors of the two wires are the same, it can be safely determined that the solenoid is not a DC latching type. number of ValveLinkers & TapLinkers per Gateway: 15, Max. (This tool can also be accessed in a web browser by visiting www.link-tap.com/health). Visit https://www.link-tap.com/video or scan the QR code for more product details.
- Banquet Table Size Chart
- Leasing Vs Buying Computers For Business
- Fibreglass Top Coat Drying Time
- Best Open Fire Grills
- Nike Tanjun Kids' Shoes
Share